These test probes should NOT be used for testing circuits of more than 50Vac, unless specified otherwise. When live circuits are tested, under no circumstances should the fuse rating exceed the quo...
These test probes should NOT be used for testing circuits of more than 50Vac, unless specified otherwise. When live circuits are tested, under no circumstances should the fuse rating exceed the quo...
These test probes should NOT be used for testing circuits of more than 50Vac, unless specified otherwise. When live circuits are tested, under no circumstances should the fuse rating exceed the quo...
These test probes should NOT be used for testing circuits of more than 50Vac, unless specified otherwise. When live circuits are tested, under no circumstances should the fuse rating exceed the quo...
The 80K-6 is a high voltage probe designed to extend the voltage measuring capability of an AC/DC voltmeter to 6000 volts peak AC or DC Overvoltage Category I. This means the probe can only be used...
In response to new ESA guidelines, Fluke introduces test probes with built-in fuses for additional measurement protection. And, if the probe fuse does blow, these probes will still allow the meter ...
EN 61010-01 ; EN 61010-2-031. Screw in tip and screw in hook. 40kV High Voltage Probe. 1000:1 voltage divider type high voltage probe For EHT checking with any digital multimeter on voltage ranges ...
The BU-7042-F-XX-X is a dual pogo tipped test probe. Each probe tip is spring loaded to promote solid contact when the probe is held at an angle or the surface being tested is uneven. The tab at th...
The BU-7042-F-XX-X is a dual pogo tipped test probe. Each probe tip is spring loaded to promote solid contact when the probe is held at an angle or the surface being tested is uneven. The tab at th...
IEC 61010-031 Ed.1.12008, CAT III 1000 V CAT IV 600 V. Fluke AC288 SureGrip™ Terminal Block Probe. The Fluke AC288 Terminal Block Probe features a retractable probe tip that provides safe and secur...
SureGrip™ accessories are designed to improve steadiness in slippery hands. Rubber overmolded surfaces and finger-hugging curves give the user a comfortable, reliable grip on the accessory so they ...
Account should be taken of the protection features and safety ratings of the test meter itself when combined with high specification test leads. Test leads and clips supplied as a pair including 1 ...
IEC 1010. Pointest test probes. Test probes offering ease of use and complete safety. These probes are fully compatible with all 4 mm diameter safety terminals. The visible metal part is limited to...
Back Probe Pin. Make connections to terminals inside connectors up to 24.39mm deep Pin can be bent to fit into tight spaces Banana jack fits modular test leads Bright yellow colour is easy to find ...
EN61010-031. Fluke TP175 and TL175 TwistGuard Test Probes. Brought to you by Fluke, TwistGuard Test Leads are the only test leads available with adjustable length test tips for use in different mea...
The Pomona Replacement Tips For .040 inch Test Probes , Model 6354 Full Kit contains ten pieces. These test probe tips fit Pomona Precision Electronic test probes that accept .040”; replacement tip...
Fluke Multimeter Test Leads and Probes. Brought to you by Fluke, a range of Test leads and probes, suitable exclusively for Fluke Multimeters. Whether it's a test lead set or a probe set, dependent...
Better than a test probe alone – these two inch long rigid back probe pins easily pass between the weather pack seal and wire. A sharp point ensures good contact to the electrical connector, and th...