arduino shop  (769 offers of 5,562,197 product items)

Type = Camera Module Number of Channels = 1 Supported Bus Interfaces = CSI-2 Maximum Supported Resolution = 3280 x 2464 pixels Maximum Frame Rate Capture = 30fps Dimensions = 23.86 x 25 x 9mm Heigh...

This is an aluminium heat Sink kit used for cooling the chips on Raspberry Pi.

The Seed Studio Heat Sink Kit for Raspberry Pi 4B is a four-piece aluminium heat sink kit which is used to cool the chip on the Raspberry Pi 4B.Made of Aluminium

The Raspberry Pi High Quality Camera is designed to work with interchangeable lenses in both CS- and C-mount form factors. The package contains a circuit board carrying a Sony IMX477 sensor, an FPC...

The SB COMPONENTS LTD, Raspberry Pi Pico Breadboard Kit is a multi-purpose Kit that consists of a 400 points half-size breadboard on top, a programmable buzzer, 4 programmable LEDs, 4 pushbuttons, ...

Accessory Category = Interface / Bridge Form Factor = HAT

The Grove Base Hat for Raspberry Pi Zero provides Digital/Analogue/I2C/PWM/UART port to meet all your needs. With the help of build-in MCU, a 12-bit 6 channel ADC is also available for Raspberry Pi...

The MonkMakes RGB LED for micro:bit provides a colourful add-on to your micro:bit. Connect it to your micro:bit with alligator clips or nuts and bolts and then use the three outputs of your micro:b...

Support Raspberry Pi 3B/3B+/4 I2C-compatible serial interface LOW current consumption: Continuous Mode: Only 150μA Single-Shot Mode: Auto Shut-Down Internal low-drift voltage reference and oscillat...

A cost-effective solution in serial communication networks. It can be used up to data rates at 10 Mbit/s or distances up to 1200m at lower speeds. This Shield is a standard add-on board for Raspber...

Seeed’s LTE CAT.1 Pi HAT is an open source cellular extension modem for Raspberry Pi, based on u-blox LARA-R2xx series. It compatible with Raspberry Pi 1 Model B+ and later versions.LTE CAT.1 Pi HA...

ADC is a common accessory for Raspberry Pi. Nowadays many cheap MCUs has built-in ADC, so we make this 8-channel ADC based on STM32F030, which is a cost-effective, low-power ARM Cortex M0 MCU. We b...

Support Raspberry 2/ 3 B/B+ Zero build-in MCU STM32 12-bit ADC Multi-type Grove port

Accessory Category = Interface / Bridge Form Factor = Addon

Product Name = ReSpeaker Dual Microphone HAT for Raspberry Pi Accessory Category = Audio Form Factor = HAT